Fluorescein isothiocyanate–dextran

CAS Number:	60842-46-8
MDL number:	MFCD00131092
NACRES:	NA.25

Кат. номер

FD4-100MG

FD4-250MG

FD4-1G

Dextran is a polymer of anhydroglucose. It is composed of approximately 95% alpha-D-(166) linkages. The remaining (163) linkages account for the branching of dextran. Conflicting data on the branch lengths implies that the average branch length is less than three glucose units. However, other methods indicate branches of greater than 50 glucose units exist. Native dextran has been found to have a molecular weight (MW) in the range of 9 million to 500 million. Lower MW dextrans will exhibit slightly less branching and have a more narrow range of MW distribution. Dextrans with MW greater than 10,000 behave as if they are highly branched. As the MW increases, dextran molecules attain greater symmetry. Dextrans with MW of 2,000 to 10,000, exhibit the properties of an expandable coil. At MW below 2,000, dextran is more rod-like. The MW of dextran is measured by one or more of the following methods: low angle laser light scattering, size exclusion chromatography, copper-complexation and anthrone reagent colorometric reducing-end sugar determination and viscosity.
FITC-dextran is used extensively in microcirculation and cell permeability research utilizing microfluorimetry. FITC-dextran has been used to study plant cell wall porosity and capillary permeability. Plasma proteins have been shown not to bind to FITC-dextran.
FITC-dextran is used in cardiovascular, microcirculation, perfusion, cell monolayer and cell membrane permeability research as fluorescent flux tracer compound that supports the measurement of processes such as blood flow, membrane damage, vascular drainage and renal elimination. Small FITC-dextrans are also used to measure processes such as endocytosis and cell junction permeability. 5kDa FITC-dextran may be used to calibrate microscale diffusion measurements. 5kDa FITC-dextran may be used to measure gut permeability in gut barrier dysfunction research.
Dextran labeled with fluorescein isothiocyanate for possible use in perfusion studies in animals.
Sigma typically tests the solubility of FITC dextrans in water at concentrations at or above 25 mg/ml. Solutions should be protected from light. In vivo, FITC-dextran is stable for more than 24 hours.

Quality Level	100
biological source	synthetic
form	powder
mol wt	average mol wt 3,000-5,000
extent of labeling	0.001-0.020 mol FITC per mol glucose
solubility	H2O: 25 mg/mL
conjugate	FITC conjugate
storage temp.	2-8°C

Pictograms	GHS07
Signal Word	Warning
Hazard Statements	H315 - H319 - H335
Precautionary Statements	P261 - P264 - P271 - P280 - P302 + P352 - P305 + P351 + P338
Target Organs	Respiratory system
Personal Protective Equipment	Eyeshields, Gloves, type N95 (US)
RIDADR	NONH for all modes of transport
WGK Germany	WGK 3
Flash Point(F)	Not applicable
Flash Point(C)	Not applicable